Ring Stretcher Size 3+ (2 piece min)

This ring stretcher will enlarge rings from size 3 (14.1 mm diameter) and up. It comes with 16 different dies to fit flat, half round, and knife-edge shank profiles of widths from 1-4mm. This device has 3 5mm (0.188”) holes in the base so it can be mounted to a bench or work table with wood screws (not included). It comes in a sturdy wooden box to hold the tool and the dies. Overall measurements of tool are 19 x 8.5 x 10 cm (7.4 x 3.3 x3.9inch).

To stretch rings, select and position the correct die. Place your ring on the shaft, and tighten the handle. Carefully rotate the handle 360 degrees, or until your ring is the desired size. More detailed instructions included with item.

Use caution when stretching rings with set stones, or stretching rings more than 1 size from original size.

Made in India

(2 Piece Minimum)